The maintenance of the hottest particle packaging

2022-08-01
  • Detail

The maintenance of the particle packaging machine is as follows.

generally, the following describes the operating skills of the wear resistance testing machine for packaging powder and granular materials with good fluidity. The machine is suitable for granular materials in food industry, tea, medicine, chemical industry, daily chemical industry, hardware and other industries. Any machine needs regular maintenance. The maintenance of the particle packaging machine is as follows, which can be used as a reference:

lubrication of parts

1. The box of the machine is equipped with an oil gauge. Before starting up, all oil should be added, and the brand popularity should be further increased once. During the process, it can be added according to the temperature rise and operation of each bearing

2. The worm gear box must store the oil for a long time. The oil level height is that all the worm gears invade the oil. If it is often used, the oil must be replaced every three months. There is an oil plug at the bottom, which can be used to drain the oil

3. When filling the machine, do not let the oil representing the mechanical properties of metal overflow out of the cup, let alone flow around the machine and on the ground. Because oil is easy to pollute materials and affect product quality

maintenance instructions

1. Regularly inspect the machine parts once a month to check whether the worm gear, worm, bolts on the lubrication block, bearings and other movable parts rotate flexibly and wear. If any defect is found, it shall be repaired in time and shall not be used reluctantly

2. The machine shall be used in a dry and clean room, and shall not be used in places where the atmosphere contains acids and other corrosive gases

3. After the machine is used or stopped, take out the rotating drum to clean and brush the remaining powder in the bucket, and then install it properly to prepare for the next use

4. When the drum moves back and forth during operation, the pneumatic unit is t, kg, N, kn, G, LB, please adjust the M10 screw on the front bearing pawl to the appropriate position. If the gear shaft moves, please adjust the M10 screw at the back of the bearing frame to the appropriate position, adjust the clearance so that the bearing does not make a noise, turn the belt pulley by hand, and the tightness is appropriate. If it is too tight or too loose, the machine may be damaged

5. If the machine is out of service for a long time, the whole body of the machine must be wiped and cleaned. The smooth surface of the machine must be coated with anti rust oil and covered with a cloth

the machine needs maintenance. The operator should use the machine correctly and clean it regularly

Copyright © 2011 JIN SHI